FLOW COMPUTER Dynamic Flow Micro MS4

Instrumentation
1

When power up only show “ticks 946 test counter”
somebody have experience with this device

2

It looks like your Flow Computer Dynamic Flow Micro MS4 is stuck in a test mode displaying “ticks 946 test counter” on startup.

Here are a few things you can try:

  1. Power Cycle the Device – Turn it off, wait a few minutes, and restart.
  2. Check for a Factory Reset or Service Mode – Some flow computers have a reset function to exit test mode.
  3. Firmware/Software Issue – If possible, check if the firmware needs reloading or updating.
  4. Inspect Hardware Connections – Ensure all wiring and sensor inputs are properly connected.
  5. Refer to the Manufacturer’s Manual – There may be troubleshooting steps for this test counter issue.